2005-2016 Ford F-250/350 Direct Replacement Adjustable Trackbar

The PMF track bar (using factory axle ball joint and biga$$ Heim-type joint) combined with the 3 Link radius arms vastly improved the handling of my 07 F350 CCLB. Truck has been leveled 2.5" with name brand lift coils, running on 35x12.50-20 Toyos. It's worth every penny to not get the cold sweats when contemplating a lane change. Castor easily adjusted and zero bumpsteer. Don't level your coil sprung Ford without these parts!

I got my Trackbar from PMF this week and boy was i excited to the have this. The stock F250 has a shimmy/Vibration that just drove me nuts. After doing some research i found this through PMF. The quality of the Trackbar is far superior to the stock OE unit and allows adjustability as well as serviceability so that should any issue arise you have the ability to repair it. PMF did an awesome job with this piece and i'm extremely happy to have this on my truck. Bye bye shimmy. vibration. Smooth sailing now. Good Job PMF

Another great product from PMF- if you are not sure what you need, call- beefy overbuilt and worth the money- should last a long time and definitely rides smoother than the stock one- allowed me to adjust the axle back where it needed to be-

My 2016 350 Super Duty was driving me nuts with bump steer and full blown death wobble. And death wobble with a 14k fifth wheel RV on the back is fucking scary. After doing a lot of You-tubing it seemed that most roads led to the track bar. I order the PMF bar and holy crap this thing is massive compared to the factory one. Be aware that when you open the box it looks different then the factory one (I have a standard height truck) but it works, you have to do some compensation adjustments to get your steering wheel straight. I also added their dual stabilizer. PROBLEM RESOLVED

Just installed my PMF trackbar and what a difference. Front axle centered again and the front end feels tight, no more wondering back and forth on the road. My only complaint was the trackbar needed to be tapped straight out of the box. There were two burrs in the thread and the heim would only screw in about 3 threads. Had to run to the store to buy a tap that size. Alittle frustrating, but all in all I'm happy with the purchase.