The triangulated bars are built from 1.5" .120 wall DOM tubing and then gusseted to prevent any unwanted axle movement. Unlike many other bars of similar design on the market we use a forged poly joint on the axle side and uniball joints on the frame side. This prevents squeaks, rattles, and premature replacement of associated parts. Be wary of kits that use heim joints on the axle side. Over time wear will cause them to creak and clunk. Dont be fooled by less expensive setups that will leave you with bent or broken bars.
All bushings supplied are heavy duty poly and grease zerks are included to prevent any squeaks. Both the front and rear of the traction bar are adjustable to allow you to fine tune the bars even if suspension lift sizes is later changed.
Our kits will work on both single and dual rear truck applications.
Special Notes: Frame will need to be drilled for front traction bar mount. Additional frame modifications may be needed for the frame mounts depending on skid plate and fuel pump configuration.
